![]() When connected to either wired eero's on the 5 I get 300 down. ![]() The eero connected via wireless is giving me worse signal than my old tplink range extender which would cut my speed in half on the 5 and still give me 180-190 down. This is an ideal placement configuration as I have no ceiling in my living room and it's mounted high up on the wall so it's basically in the center of two wired eeros (main router and 1 wired eero connected via cat6, about a 50ft homerun tested with a fluke networks nettool series II). I can only connect to the 5 if I'm standing right next to either of the two wired routers and it would require that I disconnect and reconnect to the corresponding network. I have two eeros wired (2nd floor south room/2nd floor North room) (2700sq ft home/square shaped) and one connected via wireless (1st floor center of home with open floor plan) and I'm constantly connected to the 2.4. Just installed eero and if I can't separate the Frequencies, I'll likely bring it back. Either separate the frequencies or update the software to configure devices to utilize fastest speed as opposed to best signal (QoS) Eero is a great product and mesh is an ideal concept when the proper configuration is feasible. Connections to the ideal eero are not possible with this hardware. I just hope this is a feature that could be added in the near future. Much thanks in advance! All the team members at eero have been delightful to work with. Is there some fundamental reason why this feature would be difficult to implement? In case you were wondering, I do have the IP address reserved and I have the TV set up with a static IP that matches that reservation. This is suboptimal for several reasons not the least of which it is not my first choice of a location for that eero and the televisions ethernet connection is not as fast as it's wireless connection. To remedy the situation, I had to get a specific eero and place it next to the television with the television hard wired directly into that eero. The Sony software does not appear to enjoy that experience and routinely will drop its connection completely when that occurs.įor example, I could be streaming a movie on Netflix or my kids could be watching a video on YouTube, and the Sony television will simply report an error in the middle of the video indicating it lost its Internet connection. I think there may be some gap between what the engineers think should happen with non-roaming devices and what users are actually experiencing.įor example, I have a Sony TV that, depending on what other demands there there are on my network, will shift its connection from one eero to another.
0 Comments
Leave a Reply. |